InBody Test: What It Measures and How to Read Your Results

Body Composition

Reviewed by Jaceme Chuah, RD 7 min read HDC Medical, Kuala Lumpur

Two people can weigh the same and have very different health pictures. An InBody test shows what your weight is made of: how much is muscle, how much is fat and how much is water. It takes about a minute, involves no needles and no radiation, and gives you a printed result sheet. This guide explains what the InBody test measures, how to prepare so the numbers are reliable, how accurate it is and how to read the key results.

Part of our blood test results guide: what each marker means and when it is worth testing. New to testing? Start with our guide to getting a blood test in KL.

Key takeaways

  • An InBody test is a body composition analysis : it estimates your muscle, body fat and body water, not just your weight.
  • It uses bioelectrical impedance : a very small, painless electrical current passes through your body through hand and foot electrodes.
  • For reliable results, avoid eating for 2–3 hours, avoid exercise beforehand, use the toilet first and remove metal accessories.
  • Do not take an InBody test if you have a pacemaker or other implanted electronic medical device , or if you are pregnant.
  • The most useful numbers are skeletal muscle mass, body fat percentage and visceral fat level , and how they change over time.

What is an InBody test?

InBody is a brand of body composition analyser. An InBody test (also called an InBody scan or body composition test) estimates what your body is made of: skeletal muscle mass, body fat mass, percent body fat and total body water , along with your weight and BMI.

Your weight and BMI alone cannot tell muscle from fat. A muscular person can have a high BMI, while someone with a "normal" BMI can carry too much body fat and too little muscle, sometimes called being "skinny fat". Body composition analysis fills that gap, which is why it is useful for weight management, building muscle, healthy ageing, fitness goals and tracking progress on a nutrition plan.

How does the InBody test work?

The InBody test uses bioelectrical impedance analysis (BIA) . You stand barefoot on the foot electrodes and hold the hand electrodes. The device sends a very small electrical current through your body at several frequencies and measures the resistance (impedance).

Water conducts electricity well and fat does not. Muscle holds a lot of water, so it lets the current pass easily, while fat resists it. From these readings, together with your height, age and sex, the analyser calculates your body water, lean mass and fat mass.

Segmental InBody models measure each arm, each leg and the trunk separately, so you can see whether muscle is balanced between sides and between upper and lower body. The test is non-invasive, takes about a minute and most people feel nothing at all.

What does an InBody test measure?

The exact layout depends on the InBody model, but most Body Composition Result Sheets include these measurements:

Measurement What it tells you
Weight and BMI Your total body weight and weight-for-height. BMI does not separate muscle from fat.
Skeletal muscle mass (SMM) The muscle you can build through exercise. Higher is generally better for strength, blood sugar control and healthy ageing.
Body fat mass and percent body fat (PBF) How much of your weight is fat, in kilograms and as a percentage. More useful than weight alone for tracking fat loss.
Total body water The water inside and outside your cells. Most of it sits in muscle, so more muscle usually means more body water.
Visceral fat level An estimate of the fat around your internal organs, linked to insulin resistance and heart risk. Some models show it as an area in cm².
Segmental lean and fat analysis Lean mass and fat in each arm, each leg and the trunk, to spot imbalances.
Basal metabolic rate (BMR) An estimate of the energy your body uses at rest, which helps when planning food intake.

Each result is shown against a range for your height and sex on the result sheet. Ranges and outputs vary between InBody models.

How to prepare for an InBody test

BIA is sensitive to how much water and food is in your body at the time, so preparation makes a real difference. InBody’s own guidance is:

  • Do not eat for 2–3 hours before the test. If you are having a fasting blood test at the same visit, this happens naturally.
  • Use the toilet just before the test.
  • Do not exercise beforehand on the day of the test, and avoid a sauna or shower straight before it.
  • Drink normally the day before, and avoid alcohol for 24 hours and caffeine on the day.
  • Remove metal accessories such as watches and jewellery, and take off socks or stockings.
  • Do not apply lotion on your hands or feet.
  • Stand for about 5 minutes before the test, so body water settles.

If you want to compare results over time, test under the same conditions each time: similar time of day, the same preparation and, ideally, the same device.

Who should not take an InBody test?

The current used is very small and you will not feel it, but InBody’s manuals say the test should not be used by people with a pacemaker or other implanted electronic medical device , because the current could interfere with the device. InBody also advises against testing during pregnancy.

Results can be less reliable during menstruation, with significant swelling (oedema), after a large meal or heavy exercise, or with large metal implants such as joint replacements. Let our team know beforehand if any of these apply to you.

Are InBody tests accurate?

InBody is a well-validated BIA device and is very good for tracking change over time in the same person when the test is done under the same conditions. It is an estimate, not a direct measurement: a DEXA scan is more precise for body fat, but it uses low-dose X-rays, costs more and is not usually needed for everyday health tracking.

The biggest source of error is hydration. Testing straight after a meal, a workout or a large drink can shift your body water and change the fat and muscle estimates, which is why the preparation steps above matter. A single reading is useful; a trend across several readings is more useful.

How to read your InBody results

Rather than focusing on one number, look at these together:

  • Skeletal muscle mass versus body fat mass. On the Muscle-Fat Analysis chart, weight, muscle and fat are shown as bars against a normal range. Many people see a body fat bar that is longer than their muscle bar, which points to fat loss and muscle building rather than weight loss alone.
  • Percent body fat. This tells you more than BMI. Your result sheet shows the normal range for your sex, and our team explains where you sit within it.
  • Visceral fat level. InBody’s training material treats a visceral fat level below 10 as lower risk and above 10 as higher risk. Visceral fat is closely linked to insulin resistance, raised triglycerides and blood pressure.
  • Segmental balance. Large differences between your left and right sides, or a much weaker lower body, can guide your exercise plan.
  • The trend. When you are changing your diet or exercise, InBody suggests retesting every few weeks. Tracking muscle and fat separately shows whether you are losing fat, not muscle.

In Malaysia, BMI and waist size use Asian cut-offs. The Malaysian Clinical Practice Guidelines on obesity treat a BMI of 23–27.4 as overweight and 27.5 or above as obese, lower than the international 25 and 30, because Asian adults tend to develop health risks at a lower BMI.

Why we pair InBody with your blood test

Body composition and blood results tell one story from two angles. A high visceral fat level often sits alongside a raised HbA1c , high fasting insulin or HOMA-IR , high triglycerides or low HDL on a lipid profile . Low muscle mass can explain why blood sugar is creeping up even when weight looks fine.

Reading the two together helps our dietitians set targets that make sense for your body: for example, protecting muscle while losing fat, rather than simply eating less.

InBody testing at HDC Medical

At HDC Medical in Oval Damansara, Kuala Lumpur, every blood test package includes an InBody body-composition scan , from RM599. Your InBody results and your blood results are reviewed together in a one-to-one session with our dietitian team, with nutrition guidance you can act on.

If you have a pacemaker or other implanted device, or you are pregnant, tell us when you book and we will skip the scan.

Related reading: blood test in Kuala Lumpur , insulin resistance (HOMA-IR) test , HbA1c test , lipid profile test .

References

This article is for general education and does not replace personalised medical advice. Reference ranges vary between laboratories — always interpret your results with a qualified professional. HDC Medical is a dietitian-led health screening centre in Oval Damansara, Kuala Lumpur.

Frequently asked questions

What does an InBody test measure?

An InBody test estimates your body composition: skeletal muscle mass, body fat mass and percent body fat, total body water, visceral fat level and, on segmental models, the muscle and fat in each arm, leg and the trunk. It also shows your weight, BMI and an estimated basal metabolic rate.

How much does an InBody test cost in Malaysia?

Prices are set by each facility, so they vary. At HDC Medical, an InBody body-composition scan is included in every blood test package, from RM599, together with a one-to-one review of your results.

Are InBody tests accurate?

InBody is a validated bioelectrical impedance device and is reliable for tracking changes over time when you test under the same conditions. It is an estimate: hydration, food and recent exercise affect the results, and a DEXA scan is more precise for body fat.

Do I need to fast before an InBody test?

Avoid eating for 2–3 hours before the test, use the toilet first and do not exercise beforehand. If your blood test needs fasting, the timing works out naturally.

Who should not do an InBody test?

People with a pacemaker or other implanted electronic medical device should not use it, and InBody advises against testing during pregnancy. Results may be less reliable during menstruation or with significant swelling.

What is a good visceral fat level on InBody?

InBody’s training material treats a visceral fat level below 10 as lower risk and above 10 as higher risk. It is best read together with your waist size and blood results such as HbA1c, triglycerides and insulin.

How often should I do an InBody test?

If you are actively changing your diet or exercise, InBody suggests every few weeks. Otherwise, once or twice a year alongside your health screening is enough to see your trend.

See your muscle and fat, not just your weight.

Book a dietitian-led screening at HDC Medical in Kuala Lumpur. Your results explained in plain language, with a plan to follow.

Share your love
Jaceme Chuah
Jaceme Chuah

Registered Dietitian and Dietitian Consultant at HDC Medical, Kuala Lumpur. BSc (Hons) Dietetics with Nutrition (IMU), SCOPE Certified, IDF Diabetes Educator and HRD Corp Accredited Trainer, with over 8 years of evidence-based clinical nutrition practice and 2,000+ consultations. She leads HDC Medical's one-to-one blood test report reviews and reviews the clinic's screening guides for clinical accuracy.

Articles: 32